Circuits & Schematics - 19

The article describes an RGB incident light sensor that uses colored LEDs as narrow-spectrum photosensitive elements. In the process of prototyping the RGB sensor, LEDs from the available batches were tested. However, the best results are obtained ...

You can use simple circuits to implement small, regulated plug-in power supplies. In Figure 1, a basic and versatile 5 V supply uses a zener diode and an emitter-follower transistor. You must calculate and design the transformer such that Q 1 is ...

The low-cost percentage-relative-humidity radio transmitter in Figure 1 operates in a cold-storage warehouse for vegetable storage at temperatures of 1 to 5 C. It is generally difficult to collect such data from a low-temperature area with high ...

For symmetrical applications, the circuit of Figure 4 works well. It is made up of the positive limiter already seen and a complementary negative limiter connected in parallel. A single positive reference voltage is used to control both voltage ...

I need a circuit to limit the voltage across some dissipation limited devices. It must: limit the voltage to a maximum of 1.5 V, have symmetrical limiting, be capable of accepting a current of 2 A, and leak less than 100 µA at 1 V. Two Zener ...

It is common practice to use digital open-collector outputs for control units in industrial applications. Using these outputs, you can switch loads, such as relays, lamps, solenoids, and heaters. One possible problem inherent to this type of output ...

Sometimes, you may need to make a DC/DC converter with minor components that can handle small loads. In this article, we are going to make something like that. This DC/DC converter using transistor has only a few components and can handle small ...

On June 12, 2011, the analog EE world lost a star when guru James M. Williams died. Jim’s hundreds of articles, books, and application notes were (and continue to be) a bottomless wellspring of information, inspiration, and the joy of seeing ...

Three-phase VCOs (voltage-controlled oscillators) see service in many applications, including power inverters and in electronic-music synthesis as control and modulation sources. A previous Design Idea describes a basis for a simple, three-phase ...

CMOS devices have large input impedance with input currents on the order of 0.01 nA. Adding feedback circuitry can result in a latch-like device that can be used to store bits, and also operate in a more analog mode as shown in this Design Idea, ...