RadioLocman.com Electronics ru
Advanced Search +
  
» Advanced Technologies
» Analogue Design
» Antique
» Application Notes
» Audio
» Auto-Audio
» Automation
» Automotive
» Bad Prescriptions
» Beginners
» CAD & Software
» Camcorders
» Cellular
» Computers and Peripherals
» Digital
» Domestic
» Games
» High Voltage
» Interfaces
» Laser
» Light
» MCU open-source platforms
» Measurement
» Medicine
» Microcontrollers usage
» Monitors
» Music
» Networks
» Oscillators
» Power
» Radio
» RC Modeling
» Robots
» Satellite
» Security
» Solar
» Supply
» Telephone
» Theory
» Tools and Technologies
» TV
» Video
» Wind Energy
» Wireless
Search results: 459   Output: 71-80
  1. George Qian, Linear Technology Design Note 525 Introduction Traditionally, isolated power supplies use an opto-coupler in the feedback loop to transfer regulation information across the isolation barrier. Unfortunately, an opto-coupler’s gain ...
    Circuits » Supply · Power » Linear Technology » LT3573, LT3574, LT3575, LT3511, LT3512, LT8300, LT8302
    02-07-2015
  2. Jim Drew, Linear Technology LT Journal Analog circuits often need a split-voltage power supply to achieve a virtual ground at the output of an amplifier. These split-voltage power supplies are generally low power supplies supporting tens of ...
    26-06-2015
  3. Charlie Zhao, Linear Technology Design Note 512 Introduction The trend in automobiles and industrial systems is to replace mechanical functions with electronics, thus multiplying the number of microcontrollers, signal processors, sensors, and other ...
    02-05-2015
  4. Yi Sun, Linear Technology Design Note 517 Introduction The LTC3883 is a single phase synchronous step-down DC/DC controller featuring a PMBus interface for digital control and monitoring of key regulator parameters. It has integrated MOSFET gate ...
    Circuits » Supply · Power » LTC3883
    02-05-2015
  5. Einar Abell EDN This Design Idea is a two-wire current regulator that strikes a good balance between performance and parts count. Employing three transistors, three resistors, and one LED, it achieves good regulation (better than 1% over most of ...
    Circuits » Supply » LM10
    02-05-2015
  6. Wei Gu LT Journal In a flyback converter, current levels in high current applications are constrained by heat produced in the output rectifier diode. The clear way to lift this restriction is to replace the diode with a much lower voltage drop ...
    Circuits » Supply · Power » Linear Technology » LT3748, LT8309
    21-04-2015
  7. By Albert Wu, Linear Technology EDN-Europe In many electronic systems, it is necessary to provide a bipolar (positive and negative) voltage or current into a particular type of load. Loads that require bipolar voltages/currents include FPGA body ...
    30-03-2015
  8. Zhongming Ye, Linear Technology Design Note 509 Introduction Flyback converters are widely used in isolated DC/DC applications because of their relative simplicity and low cost compared to alternative isolated topologies. Even so, designing a ...
    01-03-2015
  9. Application Note AN-932 2008 Martin Murnane, Chris Augusta Powering up a circuit on a printed circuit board is too often taken for granted and can cause damage and both destructive and nondestructive latch-up conditions. These problems may not be ...
    Circuits » Supply · Application Notes · Digital » Analog Devices » AD7621, AD7622, AD7623, AD7641, AD7643, AD7654, AD7794
    26-02-2015
  10. James Campbell Electronic Design This relatively simple circuit uses a 6-V DC supply with a PWM current-source configuration to provide efficient, adjustable dimming of a white LED over a wide range, needed to accommodate the unique lighting needs ...
    02-01-2015
 Pages:

Slices ↓
Radiolocman facebook Radiolocman twitter Radiolocman google plus