Datasheet Texas Instruments TS3USB30RSWR

High-Speed USB 2.0 (480 Mbps) 1:2 Multiplexer/Demultiplexer Switch With Single Enable 10-UQFN -40 to 85

Datasheets

PDF, 1.2 Mb, Revision: F, File published: Aug 14, 2015

Extract from the document

Lifecycle Status	Active (Recommended for new designs)
Manufacture's Sample Availability	Yes

Additional Features	Logic Controlled (Output Enabled)
Bandwidth	955 MHz
Configuration	2:1 SPDT
Crosstalk(Typ)	-56 dB
ESD Charged Device Model(Typ)	1 kV
ESD HBM(Typ)	6 kV
ICC(Max)	1 uA
Input/Ouput Voltage(Max)	4.3 V
Input/Output OFF-state Capacitance(Typ)	2 pF
Input/Output ON-state Capacitance(Typ)	7 pF
Number of Channels	2
OFF-state leakage current(Max)	2 µA
Off Isolation(Typ)	-39 dB
Operating Temperature Range	-40 to 85 C
Package Group	UQFN
Package Size: mm2:W x L	10UQFN: 3 mm2: 1.4 x 1.8(UQFN) PKG
Propagation Delay(Typ)	0.25 ns
Protocols	USB/MHL
Ron Channel Match(Max)	0.35 в„¦
Ron(Max)	10 Ohms
Ron(Typ)	6 Ohms
Turn off Time (Disable)(Max)	25 ns
Turn on Time (Enable)(Max)	30 ns
VCC(Max)	4.3 V
VCC(Min)	3 V

RoHS

Compliant

Download
Preventing Excess Power Consumption on Analog Switches
PDF, 238 Kb, File published: Jul 3, 2008
Analog switches are extensively used for switching audio signals in battery-powered applications, such as mobile phones. In any cases, the switch is powered directly from the battery, but it receives control signals from a lower voltage processor GPIO. For most analog switches, this application condition leads to an excess supply current draw that catches system designers by surprise. This applica
Download
High-Speed Interface Layout Guidelines (Rev. G)
PDF, 814 Kb, Revision: G, File published: Jul 27, 2017
As modern bus interface frequencies scale higher, care must be taken in the printed circuit board (PCB) layout phase of a design to ensure a robust solution.

Series: TS3USB30 (1)