Development system mikroElektronika ME-EASYPIC5

Detailed Description

EasyPIC5 has many features that makes your development easy.

The system supports 8, 14, 18, 20, 28 and 40 pin PIC microcontrollers (it comes with a PIC16F887 - Enhanced Flash MCU).

3 in 1 Development Tool - Development Board + USB 2.0 on-board programmer - PICFlash2 + mikro ICD on-board: mikro ICD is a highly effective tool for Real-Time debugging on a hardware level. The ICD debugger enables you to execute a mikroC/mikroPascal/mikroBasic program on a host PIC microcontroller and view variable values, Special Function Registers (SFR), memory and EEPROM as the program is running. Also there is PICFlash USB 2.0 – an ultra fast USB 2.0 programmer for fast MCU programming. Continuing its tradition as the fastest PIC programmer on the market, the new PICFlash with mikroICD now supports more PIC MCUs giving the developer a wider choice of PIC MCU for further prototype development.

Features

• External power supply connector 8 - 16V AC/DC;
• Power supply selector. It is possible to use external or USB power supply. When using USB port, there is no need for external power supply;
• Power ON/OFF switch;
• On-board USB programmer with mikroICD support. Its key feature is an ability to upgrade. By downloading anew software, it will be possible to program new MCUsin coming years;
• RS-232 communication module with selectable TX and RX for all microcontrollers;
• USB port for MCU with USB support;
• PC keyboard connector;
• DS1820 temperature sensor connector;
• A/D input selector used for testing the operation of A/D converter. It is connected to potentiometers P1 and P2;
• 7- segment displays in multiplex mode;
• 16-pin connector allows an easy connection of LCD;
• LCD contrast potentiometer;
• DIP switch SW6 turns on/off LEDs on ports A, B, C, D and E and enables digits on 7-segment LED display. DIP switch SW9 turns on/off touch panel controller, PS/2 and LCD and GLCD backlights;
• EasyPIC5 supports microcontrollers in DIP8, DIP14,DIP18, DIP20, DIP28 and DIP40 packages;
• Jumper to determine port performance in idle state (pull-up/pull-down). Select pull-up to enable port pins to detect logic zero (0) and vice versa;
• PORTA connected to a resistor network using DIP switch SW1. If a switch is OFF, the appropriate pin does not have a resistor attached. It enables PORTA pins to be used in analog mode as well as digital I/O pins. The same applies to other ports: PORTB, PORC, PORTD and PORTE;
• 36 LEDs connected to the microcontroller I/O ports;
• 20-pin connector allows an easy connection of graphic LCD;
• Graphic LCD contrast potentiometer;
• Reset circuit;
• 36 push buttons allow control of every pin on the microcontroller;
• Jumper to select high/low state of an input pin when the appropriate push button is pressed;
• Touch panel connector; and Touch panel controller.

mikroe.com

Other Names:

EASYPIC5, MEEASYPIC5, EASYPIC5, ME EASYPIC5, EASYPIC5 ME-EASYPIC5, EASYPIC5 ME-EASYPIC5