Development kit Texas Instruments CC1110DK-MINI-868

Detailed Description

The CC1110Fx features a 26MHz single-cycle 8051 microcontroller with integrated CC1101 RF transceiver, FLASH, RAM, 5 DMA channels, ADC, PWM, UART, SPI, I2S, 4 timers, and 21 GPIO pins. This kit is all you need to build a prototype of a wireless sensor node application!

The target board in this kit is very close to a real product and features:

• PCB antenna pre-tested for ETSI and FCC compliance
• battery holders for 2x AAA or 1x CR2032 coincell operation
• footprint for 2.54 mm connector connnected to CC1110Fx GPIO pins
• 2 buttons & 2 LEDs for simple application development
• pre-programmed with Link Test for RF range measurement
• SmartRF Studio and Packet Sniffer runs on the board in combination with the CC Debugger (included in the kit)

Features

• Radio
  • High-performance RF transceiver based on the market-leading CC1101
  • Excellent receiver selectivity and blocking performance
  • High sensitivity (–110 dBm at 1.2 kBaud)
  • Programmable data rate up to 500 kBaud
  • Programmable output power up to 10 dBm for all supported frequencies
  • Frequency range: 300 – 348 MHz, 391 – 464 MHz and 782 – 928 MHz
  • Digital RSSI/LQI support
• Low Power
  • Low current consumption (RX: 16.2 mA @ 1.2 kBaud, TX: 15.2 mA @ –6 dBm output power)
  • 0.3 µA in PM3 (operating mode with the lowest power consumption, only external interrupt wakeup)
  • 0.5 µA in PM2 (operating mode with the second lowest power consumption, timer or external interrupt wakeup)
• MCU, Memory, and Peripherals
  • High performance and low power 8051 microcontroller core.
  • Powerful DMA functionality
  • 8/16/32 KB in-system programmable flash, and 1/2/4 KB RAM
  • Full-Speed USB Controller with 1 KB FIFO (CC1111Fx)
  • 128-bit AES security coprocessor
  • 7 – 12 bit ADC with up to eight inputs
  • I2S interface

The Mini Development kit includes:

• 2 × SmartRFCC1110-868 target boards
• 1 × CC Debugger
• 1 × 10- pin flat cable with 2×5 2.54 mm connector
• 1 × 10-pin flat cable with 2×5 1.27 mm connector
• 1 × Converter board 2.54 mm to 1.27 mm connector
• 1 × Mini USB cable
• Batteries
• CD with Evaluation Version of the IAR EW8051 (a free 16kb kickstart version is also available for full evaluation of SimpliciTI software)
• Documentation

ti.com

Other Names:

CC1110DKMINI868, CC1110DK MINI 868