Circuits & Schematics Audio: loudspeaker
Subsection: "Audio"
Including:| Loudspeakers |
Search results: 6 Output: 1-6
- .. from. It turned out that the noise generator had no hum at all, but he was hearing the bass resonance from a badly designed loudspeaker - you can get results from these little guys!26-03-2010
- .. on the IC is a microphone preamp and AGC suitable for a low-cost electret type microphone, an output amplifier to drive a loudspeaker, memory, an oscillator, an A/D and a D/A converter. There are four basic models; 2560, 2575, 2590 ...21-09-2010
- .. For proper operation, the LM317 needs to deliver a minimum current of 4 mA from its output terminal. If your design uses no loudspeaker, you can connect a load resistor to sink this 4 mA. Designs using low-impedance loudspeakers must ...04-04-2016
- .. of the audio power amplifier (Vccp). The three grounds (one for the analog section, one for the digital and one for the loudspeaker amplifier) are indicated with different symbols on the circuit diagram and joined after the ...24-03-2013
- .. should be taken re RF emissions. We should have at least a 1st-order low pass filter between the output of the 555 and the loudspeaker or headphones. If we have long cables, the parasitic capacity of them should be taken into ...04-06-2015
- .. can invoke with the two DPDT (double-pole/double-throw) switches. If you need to hear the generated noisy signal, connect a loudspeaker to the output of IC LM386. References Generatosaur low frequency signal tone generator Materials on ...03-09-2019
Sort by: relevance / date
