Datasheet Texas Instruments UCC3817ANG4
| Manufacturer | Texas Instruments |
| Series | UCC3817A |
| Part Number | UCC3817ANG4 |
BiCMOS Power Factor Preregualtor 16-PDIP 0 to 70
Datasheets
UCCx81xA BiCMOS Power Factor Preregulator datasheet
PDF, 1.1 Mb, Revision: D, File published: Aug 31, 2016
Extract from the document
Prices
Status
| Lifecycle Status | Active (Recommended for new designs) |
| Manufacture's Sample Availability | Yes |
Packaging
| Pin | 16 |
| Package Type | N |
| Industry STD Term | PDIP |
| JEDEC Code | R-PDIP-T |
| Package QTY | 25 |
| Carrier | TUBE |
| Device Marking | UCC3817AN |
| Width (mm) | 6.35 |
| Length (mm) | 19.3 |
| Thickness (mm) | 3.9 |
| Pitch (mm) | 2.54 |
| Max Height (mm) | 5.08 |
| Mechanical Data | Download |
Parametrics
| Control Method | CCM |
| Device Type | Single-phase PFC |
| Operating Supply Current | 4 mA |
| Operating Supply(Max) | 18 V |
| Operating Temperature Range | 0 to 70 C |
| Package Group | PDIP |
| Package Size: mm2:W x L | See datasheet (PDIP) PKG |
| Peak Output Sink Current Gate Drive | 1.2 A |
| Peak Output Source Current Gate Drive | -1.2 A |
| Practical Operating Frequency(Max) | 0.25 MHz |
| Rating | Catalog |
| Special Features | > 750W Applications,Average Current Mode,Enable,OVP |
| Startup Current | 0.15 mA |
| UVLO Thresholds On/Off | 16/10 V |
Eco Plan
| RoHS | Compliant |
Design Kits & Evaluation Modules
- Evaluation Modules & Boards: UCC3817EVM
UCC3817EVM BiCMOS Power Factor Preregulator EVM
Lifecycle Status: Active (Recommended for new designs)
Application Notes
- PFC Pre-Regulator Frequency Dithering Circuit (Rev. A)PDF, 155 Kb, Revision: A, File published: May 14, 2010
PFC Pre-Regulator Frequency Dithering Circuit - PFC Family Differences UCC3817A/18A/19A and UCC3817/18/19PDF, 32 Kb, File published: Aug 18, 2003
The UCC3817A/18A/19A family of PFC controllers (UCC3817A family) is pin for pin compatible with the UCC3817/18/19 family of devices (UCC3817 family). The output stage of UCC3817A family has been updated to allow use of a smaller external gate drive resistor values. For some power supply designs where an adequately high enough gate drive resistor can not be used, the UCC3817A family offers a more r - UCC3817 Current Sense Transformer EvaluationPDF, 49 Kb, File published: Feb 13, 2004
- Synchronizing a PFC Controller from a Down Stream Controller Gate DrivePDF, 103 Kb, File published: Nov 3, 2000
Due to pending line harmonic requirements at higher power levels, power factor correction (PFC) is required in some ac-to-dc off-line power converter applications. This type of power converter can be designed with two cascaded power stages similar to the configuration in Figure 1. The first stage is a boost converter that converts the ac voltage to dc voltage with PFC. The output voltage of the bo - Startup Current transient of the Leading Edge Triggered PFC ControllersPDF, 43 Kb, File published: Jun 30, 2004
- Avoiding Audible Noise at Light Loads When Using Leading Edge Triggered PFC Con (Rev. C)PDF, 57 Kb, Revision: C, File published: Apr 13, 2011
This application note applies to the TI average current mode, leading edge modulation PFC controllers. See Applicable Device Table for part numbers. - DN-66 UC3854A/B and UC3855A/B Provide Power Limiting with Sinusoidal Input (Rev. A)PDF, 80 Kb, Revision: A, File published: Nov 6, 2001
- Accurate PWM Duty Cycle ClampPDF, 58 Kb, File published: Jan 25, 2002
Power supply applications using current sense transformers require a duty cycle clamp on the pulse width modulator (PWM) to ensure transformer reset. Not all PWMs come with a duty cycle clamp presenting a problem for the power supply designer. This application note shows how to implement a duty cycle clamp by using a simple delay circuit.
Model Line
Series: UCC3817A (5)
- UCC3817AD UCC3817ADG4 UCC3817ADR UCC3817AN UCC3817ANG4
Manufacturer's Classification
- Semiconductors > Power Management > Offline and Isolated DC/DC Controllers and Converters > Power Factor Correction
