Datasheet Texas Instruments LM329DZ/NOPB

Manufacturer	Texas Instruments
Series	LM329
Part Number	LM329DZ/NOPB

Datasheets

Prices

Parametrics

Reference Type	Shunt
Output Type	Fixed
Voltage - Output (Min/Fixed)	6.9 V
Current - Output	15 mA
Package / Case	TO-92

Status

Packaging

Eco Plan

Application Notes

• Download
  AN-298 Isolation Techniques for Signal Conditioning (Rev. B)
  PDF, 685 Kb, Revision: B, File published: May 6, 2013
  This application note provides information and examples of isolation techniques for signal conditioning.
• Download
  IC Temp Sensor Provides Thermocouple Cold-Junction Compensation (Rev. B)
  PDF, 271 Kb, Revision: B, File published: Apr 23, 2013
  Two circuits using the LM335 for thermocouple cold-junction compensation have been described. With asingle room temperature calibration, these circuits are accurate to В±3/4В°C over a 0В°C to 70В°C temperaturerange using J or K type thermocouples. In addition, a thermocouple amplifier using an LM335 for coldjunctioncompensation has been described for which worst case error can be as low as 1В°C p
• Download
  AN-301 Signal Conditioning for Sophisticated Transducers (Rev. B)
  PDF, 1.2 Mb, Revision: B, File published: May 6, 2013
  This application note discusses signal conditioning and applications information for a diverse group ofsophisticated and unusual transducers.
• Download
  AN-181 3-Terminal Regulator is Adjustable (Rev. B)
  PDF, 314 Kb, Revision: B, File published: May 5, 2013
  Until now all of the 3-terminal power IC voltage regulators have a fixed output voltage. In spite of this limitation their ease of use low cost and full on-chip overload protection have generated wide acceptance. Now with the introduction of the LM117 it is possible to use a single regulator for any output voltage from 1.2 V to 37 V at 1.5A. Selecting close-tolerance outp
• Download
  AN-256 Circuitry for Inexpensive Relative Humidity Measurement (Rev. B)
  PDF, 262 Kb, Revision: B, File published: May 6, 2013
  Of all common environmental parameters humidity is perhaps the least understood and most difficult tomeasure. The most common electronic humidity detection methods albeit highly accurate are not obviousand tend to be expensive and complex (See Box). Accurate humidity measurement is vital to a number ofdiverse areas including food processing paper and lumber production pollution monitor
• Download
  AN-263 Sine Wave Generation Techniques (Rev. C)
  PDF, 747 Kb, Revision: C, File published: Apr 22, 2013
  This application note describes the sine wave generation techniques to control frequency amplitude anddistortion levels.
• Download
  TO-92 Packing Options / Ordering Instructions (Rev. A)
  PDF, 287 Kb, Revision: A, File published: Jun 23, 2010
• Download
  Audio Applications of Linear Integrated Circuits
  PDF, 272 Kb, File published: May 2, 2004
• Download
  AN-262 Applying Dual and Quad FET Op Amps (Rev. B)
  PDF, 1.1 Mb, Revision: B, File published: May 6, 2013
  The availability of dual and quad packaged FET op amps offers the designer all the traditional capabilitiesof FET op amps including low bias current and speed and some additional advantages. The cost-peramplifieris lower because of reduced package costs. This means that more amplifiers are available toimplement a function at a given cost making design easier. At the same time the availab
• Download
  High Voltage Adjustable Power Supplies
  PDF, 87 Kb, File published: Oct 3, 2002
• Download
  AN-284 Single-Supply Applications of CMOS MICRODACs (Rev. B)
  PDF, 271 Kb, Revision: B, File published: Apr 22, 2013
  CMOS data acquisition and conversion products are becoming the ideal choice for microprocessorcontrolled analog systems. The use of CMOS allows the addition of more digital logic functionality on tothe same die as the analog circuitry to minimize external parts requirements. The inherently low powerconsumption is also a big factor for battery operation and low heat generation in large scale

Model Line

Manufacturer's Classification

• Semiconductors > Power Management > Voltage Reference > Shunt Voltage Reference