Datasheet Texas Instruments THS6052CDDA

ManufacturerTexas Instruments
SeriesTHS6052
Part NumberTHS6052CDDA
Datasheet Texas Instruments THS6052CDDA

175-mA, +/-12V ADSL CPE Line Driver 8-SO PowerPAD 0 to 70

Datasheets

175 mA +/-12 V ADSL CPE Line Drivers datasheet
PDF, 1.1 Mb, Revision: D, File published: Dec 13, 2001
Extract from the document

Prices

Status

Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityNo

Packaging

Pin8
Package TypeDDA
Industry STD TermHSOIC
JEDEC CodeR-PDSO-G
Package QTY75
CarrierTUBE
Device Marking6052C
Width (mm)3.9
Length (mm)4.89
Thickness (mm)1.48
Pitch (mm)1.27
Max Height (mm)1.7
Mechanical DataDownload

Parametrics

Acl, min spec gain1 V/V
Additional FeaturesN/A
ArchitectureCurrent FB
BW @ Acl170 MHz
CMRR(Min)59 dB
CMRR(Typ)66 dB
GBW(Typ)170 MHz
Input Bias Current(Max)10000000 pA
Iq per channel(Max)7 mA
Iq per channel(Typ)5.2 mA
Number of Channels2
Offset Drift(Typ)30 uV/C
Operating Temperature Range-40 to 85,0 to 70 C
Output Current(Typ)175 mA
Package GroupSO PowerPAD
Package Size: mm2:W x L8SO PowerPAD: 29 mm2: 6 x 4.9(SO PowerPAD) PKG
Rail-to-RailNo
RatingCatalog
Slew Rate(Typ)1700 V/us
Total Supply Voltage(Max)33 +5V=5, +/-5V=10
Total Supply Voltage(Min)9 +5V=5, +/-5V=10
Vn at Flatband(Typ)2.1 nV/rtHz
Vos (Offset Voltage @ 25C)(Max)10 mV

Eco Plan

RoHSCompliant

Design Kits & Evaluation Modules

  • Evaluation Modules & Boards: THS6052EVM
    THS6052 Evaluation Module
    Lifecycle Status: Active (Recommended for new designs)

Application Notes

  • Active Output Impedance for ADSL Line Drivers
    PDF, 636 Kb, File published: Nov 26, 2002
    Signal termination is very common in bidirectional communication systems. Termination allows for receiving signals while transmitting different signals at the same time. With the increasing popularity of asymmetrical digital subscriber lines (ADSL), the requirement for a low power line driver amplifier combined with line termination becomes a very difficult goal. This application note examines the
  • Noise Analysis for High Speed Op Amps (Rev. A)
    PDF, 256 Kb, Revision: A, File published: Jan 17, 2005
    As system bandwidths have increased an accurate estimate of the noise contribution for each element in the signal channel has become increasingly important. Many designers are not however particularly comfortable with the calculations required to predict the total noise for an op amp or in the conversions between the different descriptions of noise. Considerable inconsistency between manufactu

Model Line

Manufacturer's Classification

  • Semiconductors > Amplifiers > Operational Amplifiers (Op Amps) > High-Speed Op Amps (>=50MHz)