Datasheet Texas Instruments TPS60301DGSG4

Single-Cell to 3.0V/3.3V, 20mA Dual Output, High Efficiency Charge Pump 10-VSSOP -40 to 85

Datasheets

PDF, 1.3 Mb, Revision: B, File published: Oct 30, 2015

Extract from the document

Lifecycle Status	Active (Recommended for new designs)
Manufacture's Sample Availability	No

Iout(Max)	0.04 A
Iq(Typ)	0.035 mA
Operating Temperature Range	-40 to 85 C
Package Group	VSSOP
Rating	Catalog
Regulated Outputs	2
Special Features	Enable,Power Good
Switching Frequency(Max)	650 kHz
Switching Frequency(Min)	470 kHz
Type	Charge Pump
Vin(Max)	1.8 V
Vin(Min)	0.9 V
Vout(Max)	3 V
Vout(Min)	3 V

RoHS

Compliant

Download
Improved Start-up Performance for Charge Pumps TPS6030x
PDF, 36 Kb, File published: May 29, 2001
This document shows a solution to enhance the start-up performance of the TPS603x charge pumps. With the circuitry shown, the device can drive at start-up into full load (40 mA).
Download
Design considerations for a resistive feedback divider in a DC/DC converter
PDF, 393 Kb, File published: Apr 26, 2012
Download
Extending the Soft Start Time Without a Soft Start Pin (Rev. B)
PDF, 387 Kb, Revision: B, File published: Jun 15, 2017
Download
Choosing an Appropriate Pull-up/Pull-down Resistor for Open Drain Outputs
PDF, 130 Kb, File published: Sep 19, 2011
Download
Performing Accurate PFM Mode Efficiency Measurements (Rev. A)
PDF, 418 Kb, Revision: A, File published: Dec 11, 2018
When performing measurements on DC-DC converters using pulse frequency modulation(PFM)or any power save mode proper care must be taken to ensure that the measurements are accurate. An accurate PFM mode efficiency measurement is critical for systems which require high efficiency at low loads such as in smart home systems tablets wearables and metering.

Series: TPS60301 (4)

Semiconductors > Power Management > Non-isolated DC/DC Switching Regulator > Step-Up (Boost) > Boost Charge Pump (Inductorless)