Datasheet Microchip ATTINY861A-PU

Atmel 8-bit AVR Microcontroller with 2K
Bytes In-System Programmable Flash
ATtiny261A
Appendix A and B – ATtiny261A Specification at 105°C and 125°C
This document contains information specific to devices operating at temperatures up to
125В°C. Only deviations are covered in this appendix, all other information can be found in
the complete datasheet. The complete datasheet can be found at www.atmel.com. Rev. 8197E–AVR–11/2014 Atmel-8197E-AVR-ATtiny261A-Specification-at-105°C-and-125°C-Datasheet_11/2014 1. Electrical Characteristics
1.1 Absolute Maximum Ratings* Operating Temperature .-55п‚°C to +125п‚°C *NOTICE: Storage Temperature .-65п‚°C to +150п‚°C
Voltage on any Pin except RESET
with respect to Ground . -0.5V to VCC+0.5V
Voltage on RESET with respect to Ground . -0.5V to +13.0V Stresses beyond those listed under “Absolute
Maximum Ratings” may cause permanent
damage to the device. This is a stress rating
only and functional operation of the device at
these or other conditions beyond those indicated in the operational sections of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability. Maximum Operating Voltage .6.0V
DC Current per I/O Pin .40.0mA
DC Current VCC and GND Pins.200.0mA 1.2 DC Characteristics Table 1-1.
Symbol VIL VIH DC Characteristics. TA = -40п‚°C to +125п‚°C, VCC = 1.8V to 5.5V (unless otherwise noted).
Parameter Input Low-voltage Input High-voltage Condition Min Except XTAL1 and
RESET pins Max Units -0.5 0.2VCC(3) V XTAL1 pin,
External Clock Selected -0.5 0.1VCC(3) V RESET pin -0.5 0.2VCC(3) V RESET pin as I/O -0.5 0.2VCC(3) V Except XTAL1 and
RESET pins 0.7VCC(2) VCC +0.5 V XTAL1 pin, …

Features High Performance, Low Power AVR® 8-Bit Microcontroller Advanced RISC Architecture – 123 Powerful Instructions – Most Single Clock Cycle Execution
– 32 x 8 General Purpose Working Registers
– Fully Static Operation
– Up to 20 MIPS Throughput at 20 MHz
High Endurance Non-volatile Memory Segments
– 2/4/8K Bytes of In-System Self-Programmable Flash Program Memory Endurance: 10,000 Write/Erase Cycles
– 128/256/512 Bytes of In-System Programmable EEPROM Endurance: 100,000 Write/Erase Cycles
– 128/256/512 Bytes of Internal SRAM
– Data retention: 20 Years at 85°C / 100 Years at 25°C
– In-System Programmable via SPI Port
– Programming Lock for Software Security
Peripheral Features
– One 8/16-bit Timer/Counter with Prescaler
– One 8/10-bit High Speed Timer/Counter with Prescaler 3 High Frequency PWM Outputs with Separate Output Compare Registers Programmable Dead Time Generator
– 10-bit ADC 11 Single-Ended Channels 16 Differential ADC Channel Pairs 15 Differential ADC Channel Pairs with Programmable Gain (1x, 8x, 20x, 32x)
– On-Chip Analog Comparator
– Programmable Watchdog Timer with Separate On-Chip Oscillator
– Universal Serial Interface with Start Condition Detector
– Interrupt and Wake-up on Pin Change
Special Microcontroller Features
– debugWIRE On-Chip Debug System
– Power-on Reset and Programmable Brown-out Detection
– Internal Calibrated Oscillator …

Features High Performance, Low Power AVR® 8-Bit Microcontroller Advanced RISC Architecture – 123 Powerful Instructions – Most Single Clock Cycle Execution
– 32 x 8 General Purpose Working Registers
– Fully Static Operation
– Up to 20 MIPS Throughput at 20 MHz
High Endurance Non-volatile Memory Segments
– 2/4/8K Bytes of In-System Self-Programmable Flash Program Memory Endurance: 10,000 Write/Erase Cycles
– 128/256/512 Bytes of In-System Programmable EEPROM Endurance: 100,000 Write/Erase Cycles
– 128/256/512 Bytes of Internal SRAM
– Data retention: 20 Years at 85°C / 100 Years at 25°C
– In-System Programmable via SPI Port
– Programming Lock for Software Security
Peripheral Features
– One 8/16-bit Timer/Counter with Prescaler
– One 8/10-bit High Speed Timer/Counter with Prescaler 3 High Frequency PWM Outputs with Separate Output Compare Registers Programmable Dead Time Generator
– 10-bit ADC 11 Single-Ended Channels 16 Differential ADC Channel Pairs 15 Differential ADC Channel Pairs with Programmable Gain (1x, 8x, 20x, 32x)
– On-Chip Analog Comparator
– Programmable Watchdog Timer with Separate On-Chip Oscillator
– Universal Serial Interface with Start Condition Detector
– Interrupt and Wake-up on Pin Change
Special Microcontroller Features
– debugWIRE On-Chip Debug System
– Power-on Reset and Programmable Brown-out Detection
– Internal Calibrated Oscillator …