Evaluation Kit Texas Instruments EKS-LM3S2965

Detailed Description

The evaluation kit demonstrates a complete controller area network (CAN) using two Stellaris microcontrollers.

The main evaluation board (EVB) configures a Stellaris LM3S2965 microcontroller as a CAN host. A small CAN device board, linked with a ribbon cable, uses a Stellaris LM3S2110 microcontroller. The function of each board is fully configurable in software.You can use the board either as an evaluation platform or as a low-cost in-circuit debug interface (ICDI). In debug interface mode, the on-board microcontroller is bypassed, allowing for programming or debugging of an external target. The kit is also compatible with high-performance external JTAG debuggers.This evaluation kit enables quick evaluation, prototype development, and creation of application-specific designs for CAN. The kit also includes extensive source-code examples, allowing you to start building C code applications quickly.

Features

• Stellaris LM3S2965 microcontroller with fully-integrated CAN module
• Standalone CAN device board using Stellaris LM3S2110 microcontroller
• Simple setup; USB cable provides serial communication, debugging, and power
• OLED graphics display with 128 × 96 pixel resolution
• User LED, navigation switches, and select pushbuttons
• Magnetic speaker
• LM3S2965 I/O available on labeled break-out pads
• Standard ARM 20-pin JTAG debug connector with input and output modes
• USB interface for debugging and power supply

Features of the LM3S2965 Microcontroller

• 32-bit RISC performance using ARM Cortex-M3 v7M architecture
  • 50-MHz operation
  • Hardware-division and single-cycle-multiplication
  • Integrated Nested Vectored Interrupt Controller (NVIC)
  • 27 interrupt channels with eight priority levels
• 256-KB single-cycle flash
• 64-KB single-cycle SRAM
• Four general-purpose 32-bit timers
• Controller area network (CAN) module
• Three fully programmable 16C550-type UARTs
• Four 10-bit channels (inputs) when used as single-ended inputs
• Three independent integrated analog comparators
• Two I2C modules
• Three PWM generator blocks
  • One 16-bit counter
  • Two comparators
  • One PWM generator
  • One dead-band generator
• Two QEI modules with position integrator for tracking encoder position
• Two synchronous serial interfaces (SSIs)
• 3 to 56 GPIOs, depending on user configuration
• On-chip low drop-out (LDO) voltage regulator

Evaluation Kit Contents

• LM3S2965 evaluation board (EVB)
• LM3S2110 CAN device board
• USB cable
• 20-pin JTAG/SWD target cable
• 10-pin CAN cable
• CD containing:
  • Texas Instruments’ Code Composer Studio IDE
  • Complete documentation
  • Quickstart application source code
  • Stellaris Firmware Development Package with example source code
     

Schematic diagram EKS-LM3S2695 development board

ti.com

Other Names:

EKSLM3S2965, EKS LM3S2965