Datasheet LXHL (Lumileds) - 7

Absolute Maximum Ratings Table 5.
White/Green/ Red/ Cyan/Blue/ Warm RedOrange/ Parameter Royal Blue White Amber DC Forward Current (mA) [1] 350 350 385 Peak Pulsed Forward Current (mA) 500 500 550 Average Forward Current (mA) 350 350 350 ESD Sensitivity [2] ± 16,000V HBM LED Junction Temperature (°C) 135 120 120 Storage Temperature (°C) 40 to +120 40 to +120 40 to +120 Soldering Temperature (°C) [3] 260 for 5 260 for 5 260 for 5 seconds max seconds max seconds max Notes for Table 5: 1. Proper current derating must be observed to maintain junction temperature below the maximum. For more information, consult the LUXEON Design Guide, available upon request. 2. LEDs are not designed to be driven in reverse bias. Please consult Philips Lumileds' Application Brief AB11 for further information. 3. Measured at leads, during lead soldering and slug attach, body temperature must not exceed 120°C. LUXEON emitters cannot be soldered by general IR or Vaporphase reflow, nor by wave soldering. Lead soldering is limited to selective heating of the leads, such as by hotbar reflow, fiber focussed IR, or hand soldering. The package back plane (slug) may not be attached by soldering, but rather with a thermally conductive adhesive. Electrical insulation between the slug and the board is required. Please consult Philips Lumileds' Application Brief AB10 on LUXEON Emitter Assembly Information for further details on assembly methods. LUXEON Emitter DS25 (5/07) 7