Development Kit Texas Instruments CC2533DK-RF4CE-BA (updated version)

Detailed Description

The CC2533 RF4CE development kit supports TI's second generation 2.4GHz IEEE 802.15.4 compliant System-on-Chip, the CC2533, and contains all hardware, software, and tools necessary to evaluate, develop, test, and debug an RF4CE-compliant product.

The CC2533 RF4CE development kit includes an advanced programmable remote control with motion sensors (3-axis accelerometer and 3-axis gyroscope), a simple form factor programmable remote control, a target module (receiver board) that interfaces to PC remote control emulation software via USB, two different USB dongles and all debugging equipment and cables needed to use the kit for developing basic remote controls, advanced remote controls with mouse-like pointing and keyboard functionality and consumer electronics products.

The CC2533 RF4CE development kit is designed to support development on TI's industry leading RF4CE-compliant software architecture, RemoTI. The RemoTI installer, available at www.ti.com/RemoTI, comes with the core stack library, ZRC and ZID profile support, remote control sample application code, a PC emulator tool, over the air download and serial boot loader demonstration code, an 802.15.4 packet sniffer, flash programmer, and more.

Features

• Advanced RF remote control
  • A complete RF4CE remote control reference design with gyro and accelerometer enabling air mouse functionality and with an integrated PCB antenna. The remote control can be programmed using the debug interface.
• Basic RF remote control
  • A simple RF remote control optimized for ZigBee Remote Control (ZRC). Enables all the basic remote control functions, the remote control can be programmed using the debug interface.
• Target Module
  • Interface board for connecting I/O signals to typical
  • remote applications. The following interfaces are
  • accessible:
  • UART over USB virtual serial port
  • UART, CMOS signal level
  • SPI
  • I2C
  • IR receiver/transmitter
• CC Debugger
  • USB Debug Interface for programming and debugging applications running on the remote control and target board.
  • For programming the CC Debugger is used with the SmartRF Flash Programmer SW
  • For In-Circuit debugging the CC Debugger is used with the IAR Embedded Workbench.
• CC2531 USB dongle
  • The USB dongle can be programmed to replace the functions of the Target Module. It supports virtual serial port interface and HID (Human Interface Device) USB profiles. It can also be programmed to be used as packet sniffer of RF activity.
• CC2531 Nano USB stick
  • The CC2531 Nano USB stick is a miniaturized version of the USB dongle and has all the functionality of the USB stick except from the peripherals, i.e. buttons and 
  • LEDs. The Nano USB stick is pre-programmed with a bootloader for easy FW upgrades.
• CC2533EM
• This is the CC2533 Evaluation Module (EM) with the RF IC reference design. Use the EM as reference design for antenna and RF layout. To be plugged into the Receiver module. The CC2533EM module includes both a no-cost PCB antenna and an SMA connector with external antenna. The antenna can be selected with a 0-ohm resistor.
   

Kit includes:

• The CC2533 RF4CE development kit comes with:
• 1 x Advanced Remote Control
• 1 x CC2533-based RF Remote Control Target module (receiver board) with CC2533EM module
• 1 x CC2531 Nano USB stick
• 1 x CC2531 USB Dongle
• 1 x Basic Remote Control (programmable)
• 1 x CC Debugger
• Cables
• Documentation 

ti.com

Other Names:

CC2533DKRF4CEBA, CC2533DK RF4CE BA