Development Board mikroElektronika ME-EASYDSPIC4A

Detailed Description

It is designed to allow students and engineers to easily test and explore the capabilities of these dsPIC microcontrollers. It also allows dsPIC30 microcontrollers to be interfaced with external circuits and a broad range of peripheral devices. The user can therefore concentrate on software development only.

3 in 1 Development Tool - Development Board + USB 2.0 on-board programmer - dsPICprog2 + mikro ICD on-board: mikro ICD is a highly effective tool for Real-Time debugging on a hardware level. The ICD debugger enables you to execute a mikroC/mikroPascal/mikroBasic program on a host dsPIC microcontroller and view variable values, Special Function Registers (SFR), memory and EEPROM as the program is running. Also there is dsPICprog2 USB 2.0 – an ultra fast USB 2.0 programmer for fast MCU programming. Continuing its tradition as the fastest dsPIC programmer on the market, the new dsPICprog2 with mikroICD now supports more dsPIC MCUs giving the developer a wider choice of dsPIC MCU for further prototype development.

EASYDSPIC4A KEY FEATURES

• External power supply of 8v to 16v AC/DC;
• On-Board USB 2.0 programmer with MikroICD (In-Circuit debuger);
• RS-232 communication port, ICD2 external programmer connector;
• A/D converter test input potentiometers;
• 2X16 character LCD display in 4-bit mode conector;
• EASYdsPIC4A supports microcontrollers in DIP18, DIP28, and DIP40 packages;
• OSC2 oscillator connector;
• Jumpers to determine input pin performance in idle state (connected to pull-up/pull-down resistor);
• Resistor network 8x10K, direct port access connectors;
• Each I/O pin corresponds to one LED;
• LCD contrast potentiometar;
• Switch group SW7 allowing all LEDs on ports A,B,C,D,E and F to be connected or disconnected from MCU pins. Switches 6 and 7 of the same group enable LCD and GLCD backlight.;
• GLCD contrast potentiometer;
• OSC1 crystal (10Mhz);
• Reference voltage source 4.096V;
• Switch groups SW1-SW6 enabling pull-up/pull-down resistors on port pins;
• RESET push-button;
• Jumper J15 is used to select high or low state of pins on any button press;
• 41 push-buttons allowing control of all microcontroller pins.
• CN11 touch panel connector;
• Graphic LCD display (GLCD) connector;
• Touch panel switch (SW8) enabling/disabling connection between touch panel and microcontroller;
• Touch panel controller.

Other Names:

MEEASYDSPIC4A, ME EASYDSPIC4A