Circuits & Schematics

Piezoelectric actuators (benders, stacks, chips, etc.) are excellent fast and precise means for generation and control of micro, nano, and even atomic scale movement on millisecond and faster timescales. Unfortunately, they are also excellent ...

Using the system shown in Fig. 1, you can quickly test a cable containing twisted-wire pairs and detect open or reversed pairs, shorted pairs, and shorts between unrelated pairs. The tester consists of an active test set that plugs into one end of ...

Introduction Photovoltaic (PV) modules are popular and affordable sources of renewable energy. Most photovoltaic modules last about 20 years, but thermal stress and moisture ingress, among other causes, can degrade a module’s output power ...

In 1986, famed analog innovator Jim Williams, in “Designs for High Performance Voltage-to-Frequency Converters” ( Reference 1 ) published his 100 MHz “King Kong” VFC. If anyone’s ever done a faster VFC, I haven’t ...

Analog-to-digital conversion based on the classic combination of a voltage-to-frequency converter (VFC) with a counter has been around for (many) decades, mainly because it has some durable time-proven advantages. VFC digitization is naturally ...

Some applications, such as ADC testing and calibration, require a DAC with extremely good resolution, monotonicity, accuracy, and resolution. In these categories of performance, the circuit in Figure 1 is hard to beat. Its typical specifications ...

Let’s imagine that you need to add a power switch to something that’s battery-powered but processor-free; perhaps it must also be waterproof and thus membrane-sealed. Or perhaps you just want to use a shiny modern push-button rather ...

The CD4011 CMOS NAND gate has a typical input current of 10 pA at room temperature. You can charge a capacitor connected to the gate input with currents on the order of hundreds of picoamperes and neglect the influence of the gate-input current on ...

The exposure tester in this Design Idea measures the on time of a light source, whether an LED, an incandescent lamp, a halogen lamp, or another source. It can be made with an ordinary stopwatch and a few simple components (figures 1 and 2). An ...

It is common practice to power a MOSFET with a comparator and with an unregulated voltage and to power the comparator driving it from a regulated one (Figure 1). Many loads are insensitive to driving voltage, so it would be a waste of money and ...