RadioLocman.com Electronics ru
Advanced Search +
  
  Including:
 » AVR  » Clock  » PIC  » Programmer
» Advanced Technologies
» Analogue Design
» Antique
» Application Notes
» Audio
» Auto-Audio
» Automation
» Automotive
» Bad Prescriptions
» Beginners
» CAD & Software
» Camcorders
» Cellular
» Computers and Peripherals
» Digital
» Domestic
» Games
» High Voltage
» Interfaces
» Laser
» Light
» MCU open-source platforms
» Measurement
» Medicine
» Microcontrollers usage
» Monitors
» Music
» Networks
» Oscillators
» Power
» Radio
» RC Modeling
» Robots
» Satellite
» Security
» Solar
» Supply
» Telephone
» Theory
» Tools and Technologies
» TV
» Video
» Wind Energy
» Wireless
Search results: 387   Output: 61-70
  1. This shield allows to connect an Arduino with DMX equipment (Figure 1). It implements the RS485 interface to adapt the electrical levels needed for DMX connection. This shield has been designed with flexibility in mind and allows the user to choose ...
    23-01-2013
  2. This project is about building a microcontroller-based digital room thermometer plus hygrometer that displays temperature and relative humidity on 4 large (1 inch) seven segment LED displays which adjust their brightness level according to the ...
    18-01-2013
  3. Igor Lovrić Few months ago, I got request to find some kind of solution to measure G-Forces in moving car. I found a lot of commercial products on net, but in my country it is little bit difficult to buy them, so I decided to make my own ...
    17-01-2013
  4. Part 1 - Theory and Schematic Operation of the board The operation of the board is very simple. After powering the board from a 3-5.5 V supply, the Enable (EN) pin must be pulled high to activate the IR sensor. Next, place the tip of your ...
    24-12-2012
  5. When I first built the Heart rate measurement through fingertip project, the infrared LED and photodiode used for finger photoplethysmography were actually from salvaged parts, and therefore, I could not provide specifications for them in the ...
    30-11-2012
  6. The thermocouple is a kind of the temperature sensors. It is inexpensive and the measureing range is very wide compared to thermisters or temperature sensor ICs. However because the output voltage is small and relativistic, the thermocouple ...
    26-11-2012
  7. Part 1 - Hardware and Schematic Part 2 - Robots Filippo, Bipe and Spider Let us see now the analysis of the firmware describing those functions that are common to all the robots such as the procedure that reads the distance from obstacles by means ...
    19-11-2012
  8. Filippo robot Filippo is a biped robot whose movements are assigned to only two servos, but with this robot you can experiment with robotics without spending large sums. It is able to walk and turn around, then you can direct it in any direction, ...
    18-11-2012
  9. Part 1 - Theory In the first part of this discussion, the features of ACS712 device were briefly discussed. Now we will use that theory to implement the ACS712 sensor to make a simple DC current meter. The analog output voltage from the sensor is ...
    10-11-2012
  10. Sensing and controlling current flow is a fundamental requirement in a wide variety of applications including, over-current protection circuits, battery chargers, switching mode power supplies, digital watt meters, programmable current sources, ...
    10-11-2012
 Pages:

Slices ↓
Radiolocman facebook Radiolocman twitter Radiolocman google plus