Circuits & Schematics NXP - 2
Manufacturer: "NXP"
Search results: 25 Output: 11-20
- Jose Miguel-Lopez EDN The TDA7000 integrates a monaural FM-radio receiver from the antenna connection to the audio output. External components include one tunable LC circuit for the local oscillator, a few capacitors, two resistors, and a ...13-12-2018
- Nick Ierfino Electronic Design In many situations, designers must control the phase of an output signal in order to make certain circuits work properly. At low frequencies, an op amp can be used to vary the phase. But as the frequency gets into the ...07-06-2018
- Abel Raynus EDN Rechargeable NiCd (nickel-cadmium) cells are widely used in consumer devices because of their high energy density, long life, and small self-discharge rate. As a part of one project, I needed to design a reliable and inexpensive ...05-12-2017
- SK Kaul and IK Kaul EDN The absence of a fast one-shot multivibrator in the entire TTL family, as well as the low-voltage swing and unwieldy supply requirements of ECL, drove us to exploit the fast transition times and low propagation delays of ...15-01-2017
- An inexpensive way to implement high-resolution digital-to-analog conversion is to combine microcontroller-PWM (pulse-width-modulated) outputs with precision analog-voltage references, CMOS switches, and analog filtering ( Reference 1 ). However, ...09-11-2016
- The idea of using a super-regenerative radio to receive commercial FM stations can be found at various locations on the Internet. Because the circuit is so small, it might be impressive to lab visitors, especially to children. But the basic ...18-10-2016
- Alfredo Saab EDN Analog applications, such as testing, calibration, and general system operation, often require a sine waveform of accurate amplitude and frequency, with low THD (total harmonic distortion). Some applications demand that the ...11-08-2016
- The voltage doubler described in this Design Idea is a modification of the Dickson charge pump. Unlike that circuit, it needs no DC input voltage, but only a digital clock whose peak value is ideally doubled at the output as a DC voltage. The ...12-05-2016
- Andrew Russell EDN The circuit in Figure 1a is a low-cost isolation amplifier for instrumentation applications that provides as much as 500 V of galvanic isolation between input and output. The amplifier uses only one small, low-cost transformer ...31-01-2016
- Circuits Wireless Microcontrollers Usage Radio Light Networks Application Notes NXP JN51xx SSL2108 SSL2108 UBA2027 UBA3070Application Note JN-AN-1166 Version 1.1 December 2013 This application note provides and describes a set of NXP software drivers for use with ‘smart lamps’. These software drivers are intended to be used in applications that run on ...04-01-2014
Sort by: relevance / date
