Circuits & Schematics: CLOCK - 8
Search for: "CLOCK"
Search results: 254 Output: 71-80
- .. monitor in my spare time. The I2C bus was developed by Philips in the 1980’ s. It is a serial bus, consisting of a clock and data line. The protocol specifies START and STOP conditions, the data format (8 bits, MSB first), and and ...May 20, 2010
- .. Mijanovic, Nedjeljko Lekic Part 1 - Schematic Let us look at the first shift register. The microcontroller drives CLOCK input directly. The same signal passes through the RC filter and drives DATA input D (Figure 5). The RC filter ...May 11, 2013
- Circuits Microcontrollers Usage Atmel Attiny11 Attiny12 Attiny13 Attiny15 Attiny25 Attiny45 Attiny85.. to further repair on SPI normal programmer. Do not use this option with Attiny11 or Attiny15 . Fusebits: internal 4 MHz clock not divided by 8. Will be good to select the “fast rising power” too. Update 3 May 2010 : If you ...May 26, 2010
- .. it, device for repairing dead Atmega family AVRs by writing wrong fusebits. Most common mistakes or problems are a wrong clock source (CKSEL fusebits), disabled SPI programming (SPIEN fuse) or disabled reset pin (RSTDISBL fuse). This ...Jun 2, 2010
- .. (later on tested with transcend cards also). The microcontroller is AVR ATmega8 or ATmega32 running at 8Mhz internal clock. MAX232 is used to interface the circuit with PC for monitoring the data. A 3.3v supply is used for powering ...Jun 18, 2010
- .. at this bus. No incompatibilities have been reported so far. The I 2 C-tiny-usb provides a software adjustable I 2 C clock delay allowing to configure the I 2 C clock. The default delay is 10us. Due to additional delays in the i2c ...Jul 15, 2010
- .. Consumption: The ATtiny45 includes low power modes. The “idle” sleep mode will be used. During sleep, the CPU clock is running at 31kHz (reduced just before entering sleep mode), so according to Figure 25-6 of the ATtiny45 data ...Jun 25, 2010
- .. calibrated to 8 MHz. The frequency measurement probe is connected to W1 terminal, which is then fed to the pin PB0 and the clock input of the 74HC191 4-bit counter. The 4-bit counter will be used to divide the measured frequency by 16 ...Jun 29, 2010
- .. with the CPLD. The SPI interface The serial peripherial interface (SPI) is a synchronous serial interface. It uses a clock line and a seperate data in- and output connection which are used to transfer bytes one bit after the other. A ...Jun 30, 2010
- .. (transmitter unit) Signal Description PS/2 pin Comments VCC +5V power 4 must be connected to module GND Power ground 3 CLK Clock 5 DATA Data 1 NC Unused lines 2, 6 not used by module if present, leave in original state SHLD Shield USB plug ...Jul 20, 2010
Sort by: relevance / date
