Circuits & Schematics Linear Technology - 8
Manufacturer: "Linear Technology"
Search results: 124 Output: 71-80
- Glen Brisebois EDN Ideal triangle waves involve infinite d 2 V/dt 2 , so high-fidelity triangle waves entail very high bandwidths. Micropower circuits have fairly low bandwidth, so generating good triangle waves with such circuitry becomes ...19-01-2017
- The VFC (voltage-to-frequency-converter) circuit in Figure 1 achieves a wider dynamic range and a higher full-scale output frequency 100 MHz with 10% overrange to 110 MHz by a factor of 10 over any commercially available converter. The ...19-01-2017
- You use a JFET's self-biasing characteristics to build a dc/dc converter that operates from power sources such as solar cells, thermopiles, and single-stage fuel cells, all of which deliver less than 600 mV and sometimes as little as 300 mV. ...11-01-2017
- Raymond Zheng, Linear Technology EDN The demand for negative-voltage power supplies is increasing with the popularity of applications for portable devices. It can be expensive and relatively complicated to generate a negative supply from a positive ...06-01-2017
- In certain dc/dc-converter applications, on-chip, cycle-by-cycle current limit may be insufficient protection to prevent a failure during a short circuit. A nonsynchronous boost converter provides a direct path from the input to the short circuit ...14-12-2016
- Bob Smith, Linear Technology Design Note 1036 Introduction The LTC®4370 is a 2-supply current sharing, diode- ORing controller that uses MOSFETs to form ideal diodes. In this way, the LTC4370 can actively balance the output currents of two ...02-12-2016
- Despite the long-predicted demise of the 4- to 20-mA current loop, this analog interface is still the most common method of connecting current-loop sources to a sensing circuit. This interface requires the conversion of a voltage signal typically, ...01-12-2016
- Sajjad Hajdar Electronic Design Most common current-limiting implementations have a voltage drop that’s too high for today's systems with their low-voltage supply rails; this design with its far lower voltage drop is a better fit. There ...18-11-2016
- Gheorghe Plasoianu EDN Bench electronic loads are usually rated for voltages less than 100 V, which make it difficult to test high-voltage power supplies. This Design Idea offers an alternative: an inexpensive electronic load rated for 500 V or ...24-10-2016
- Design Note 548 Synchronous buck-boost converters with four power switches can deliver very high efficiency while providing both step-up and step-down DC/DC conversion. Combining the capabilities of two separate converters (buck and boost) has the ...18-10-2016
Sort by: relevance / date
