Circuits & Schematics: Design - 3

Search for: "Design"
Search results: 979 Output: 21-30
  1. .. than 0.1 K. The output at Q 1 ’s collector can sink several milliamperes at a voltage excursion of 0 to 5 V. This design can accommodate temperature-to-frequency converters and other types of temperature sensors. References MAX845 ...
    Jun 23, 2020
  1. Circuits Analogue Design Audio Measurement Analog Devices LT6202 LTC2380-24 LTC6363 LTC6655
    .. Hoover, Analog Devices Electronic Design A high-resolution SAR ADC often needs a higher-order antialiasing filter, such as the third-order version ...
    Jul 12, 2020
  1. .. while leaving much of the AVR functionality for other use and allowing fast and reliable WLAN data transfers. The final design was based on a PRISM chipset based compact flash WLAN card which is connected to the AVR CPU using a ...
    Jun 30, 2010
  2. Circuits Supply Analog Devices LT3015 LT3090 LT3094 LT8582
    .. Zhu, Analog Devices Design Note Low dropout (LDO) linear regulators have been widely used in noise-sensitive applications for decades. ...
    Jan 13, 2020
  3. .. Nopper Electronic Design Incremental-rotation or linear encoders are very common, but normally they do not provide a direction signal. ...
    Dec 30, 2019
  4. Giovanni Romeo
    .. mirror (Figure 2). Figure 2. This voltage-controlled power supply uses a current mirror. The precision you get from this design is tied to the precision of the current mirror you’ll use. If you decide for the Widlar basic ...
    Jan 14, 2020
  5. Dimitri Danyuk
    .. is a portion of Q3’s emitter current. This can be helpful when Q1’s quiescent current is determined by other design objectives for example, noise performance. Figure 3. If the ratio of R3/R4 is changed, the required value of ...
    Dec 24, 2019
  6. .. for offset voltage calibration elsewhere in the circuit, or it could be turned off when it isn’t in use. Space and design time can be saved by avoiding having to set up separate biasing schemes. Some DACs, such as the MCP4728, also ...
    Feb 29, 2012
  7. .. is the 9 volt GS transmitter which does not use a crystal. This clever design allows only two transistors to generate both the carrier and and the modulation. Shown below at 27MHz 40MHz ...
    Mar 8, 2005
  8. Shyam Tiwari
    .. that need transistor-transistor logic (TTL) or CMOS signals, which can make such sensors difficult to use. This design (see the figure) provides a simple solution to the interface problem when the sensor uses an NPN output stage ...
    Feb 23, 2012

Sort by: relevance / date

Search "Design" on other search engines: Only-DataSheet.com Google